Request A Quote

Thermoset Plasticator

Thermoset Plasticator

The LMG Plasticator is a screw type pre-plasticating unit that was designed and built to preheat and preform thermoset materials such as BMC, Epoxy, and Phenolic for transfer or compression molding. The preheater combines two steps, preforming and preheating the material into one step and delivers very accurate shot sizes. Plasticating the material results in molding cycles that are more consistent and produces molded parts with higher quality.


Standard Features

  • 15HP Hydraulic Power Unit to provide greater process ability
  • Control System with position feedback and proportional screw speed control
  • Through-Hardened H13 Tool Steel Knife
  • Multiple Programmable shot sizes to add flexibility to your molding process
  • Back-Pressure Monitoring
  • Barrel Insulation Blankets for heat control and reduced energy losses
  • Easy Operator Controls for increased efficiency of set-up and operation
  • Extra Large Reservoir
  • Manifold Mounted Hydraulics
  • LMG Quick Change Screw and Barrel feature
  • High Grade Screw available in several sizes
  • Shot Size Capability from a few ounces up to 10 pounds
Thermoset Plasticicator

Not sure what you need?

Call and speak with one of knowledgeable application experts to get started today!!

Our success is measured by your success.