Request A Quote

Paraguide Series Compression / Transfer Presses

500 Ton Compression Hydraulic Press
500 Ton Press

LMG’s robust Paraguide press features 45° gib guided columns that provide for tighter parallelism control than can be achieved with a round tie rod press. This design can also reduce deflection that can be caused by slightly off center loads. With this design, your press maintains its guiding when the moving platen grows during the molding process. The wear components are then easy to adjust so that clearances can be run tight or replaced. These presses are offered in both Down-Acting and Up-Acting configurations.


Standard Features

  • Two-handed, anti-tie-down cycle start buttons
  • Adjustable Pressure
  • Adjustable Clamp Speeds
  • Manifold mounted valves
  • Hydraulic circuit test ports
  • Color touch screen
  • Three sided mechanical guarding
  • Positive head pump suction
  • Solenoid indicating lights for ease of troubleshooting
  • Quiet Operation
  • Mechanical latch bar for down-acting presses

Available Options

Our success is measured by your success.